Why is My Refrigerator Water Dispenser Not Working?

Is the water dispenser on your refrigerator not working? If so, you can try to repair the issue on your own or call Champion Deltona Appliance Repair for refrigerator repair Deltona, Florida.

There are a lot of reasons for the water dispenser in a refrigerator to not work. Again, some of the suggestions are going to sound a bit crazy. However, something as obvious as a power switch on the refrigerator has been the reason in the past. Be sure to inspect the obvious potential problems prior to proceeding with complicated refrigerator repair. Let’s start to cover this appliance repair problem and see what solutions we can reference for a broken water dispenser on a refrigerator.

The reason for a broken water dispenser is typically either an installation issue, a filter failure or frozen water lines:

Refrigerator Installation Problems

You just installed a brand new refrigerator for your kitchen with a water dispenser, but it is not working. The water dispenser must be connected to the water line. That might be the cause of the issue.

If the new refrigerator is replacing an older refrigerator that did not feature an ice maker or water dispenser, there’s a chance that you don’t have a functioning water line running to this area of the kitchen. A water line is usually run from under the house either in a crawl space or basement. You can purchase this line at almost any home repair store and they are very easy for even the typical homeowner to install. Typically they have include a built-in water shut-off valve, which is necessary so that if you need to move the refrigerator, you can shut off the water.

If you have an attached water line, is the valve on? The valve handle needs to be in line with the hose. And, is there water going through the pipe that you have used to connect the water line? Simple and questions, but items that have to be checked.

If you had to remove the doors during installation it’s possible the water dispenser may not be plugged in. Review the owner’s manual to see the wire harness for the particular refrigerator. Be sure that it’s plugged into the refrigerator.

When the water is connected, usually there’s air in the line. So, lifting and lowering the water dispenser control on the refrigerator to get the air out of it is needed.
Filter Problems

On some models, there are various filters. These filters might “expire”, clog or become frozen. All filters are based on your model and brand of refrigerator. If the filter is clogged it will cause slow filling or no flowing period. It’s recommended that your filter be changed every 6 months. Replacing filters can be hard sometimes. If you have problems, go online and find the right method to replace a filter.

One recommendation is to fill the water filter with water before installing it. A lot of time the water filters need a long time to fill, which could cause you to believe the water dispenser is not working right. You should read the directions if all else fails. To ensure it is not air trapped in the water lines, depress the dispenser lever for about 5 minutes.

A frozen water tank might also be the cause of the problem as well on some refrigerators. If the tank freezes it will leak onto the food bins. Low amounts of food inside of the fresh food bins could cause freezing to happen.